Concentrated measurement of direct current | Monitoring multiple disaster prevention bases and facilities together.
Monitor multiple disaster prevention bases and facilities collectively. Continuously measure direct current, and remotely check current values, load fluctuations, and history.
At disaster prevention bases and important facilities, measuring and recording the direct current circuit from the emergency power supply to the load equipment on-site takes time, making it difficult to grasp changes that occur between patrols. The "iDC-SVS4" continuously measures direct current with sensors that support 30A, 50A, 100A, 250A, and 500A, and sends the measurement data to a monitoring server. Current values, load fluctuations, and past history can be checked remotely, and in combination with monitoring software, it also supports notifications based on set thresholds. In the event of communication failure, data is temporarily stored in a relay device and sent after communication resumes to prevent loss of history. Usage scenarios: - Monitoring direct current at disaster prevention bases and important facilities - Checking current values and history of the direct current circuit from the emergency power supply to the load equipment - Confirming inspection targets and notification status before on-site visits Expected benefits from implementation: - Understanding current changes over time outside of patrols - Aggregating numerous measurement points into a common monitoring environment - Utilizing normal operation history as reference information for inspections and BCP verification We will propose configurations based on monitoring targets, number of circuits, cable diameter, and installation environment.
